Optec FocusLynx Second Stepper Control Board Online now

Optec FocusLynx Second Stepper Control Board

Optec FocusLynx Second Stepper Control Board

The Optec FocusLynx Second Stepper Control Board is a small circuit board which can be installed inside an existing FocusLynx Hub. It provides the control circuit for a second motorized focuser unit, etc.

Take control of your astronomical accessories the easy way! The FocusLynx Second Stepper Control Board would be a great addition if you want to control two separate Optec motorized units remotely, using just one Hub box. You can independently control up to two Optec or Starlight focusers through a computer, smartphone, or hand control. Each focuser may be plugged into the hub using standard serial cables. The FocusLynx can then be connected to a computer via serial cable, Ethernet, or wireless network (with purchase of the extra FocusLynx Wireless Board accessory). Once connected, are ready to go!

The Second Stepper Control Board can be easily installed by the user. Just remove the top lid from the Hub (by removing only four screws) and the Control Board will plug into the Mother Board already located within that box.

Note: It is strongly recommended that the installer uses a static grounding strap, in order to prevent ESD (static) damage to the electronics.

Here is the Optec video site which demonstrates how to install this kit:

This part number for this item is OP-19533.

• This is a small circuit board which can be installed inside an existing FocusLynx Hub.
• Control circuit for a second motorized focuser unit so you can take control of your astronomical accessories the easy way!
• Lets you control two separate Optec motorized units remotely, using just one Hub box.
• You can independently control up to two Optec or Starlight focusers.
• Control through a computer, smartphone, or hand control.
• Plug each focuser into the hub using standard serial cables.
• Connect the FocusLynx to a computer via serial cable, Ethernet, or wireless network. (Wireless requires the extra FocusLynx Wireless Board accessory). 
• The Second Stepper Control Board can be easily installed by the user.
• Note: It is strongly recommended that the installer uses a static grounding strap, in order to prevent ESD (static) damage to the electronics. See the Optec video below which demonstrates how to install this kit.